i was wondering if anyone out there somewhere in socal has a plasma cutter or just anything that cuts... cuz i need to make some cuts on my xj body if someone out there has one i can use i would appreciate it :)

4.5" angle grinder with a cut off wheel works great for body panels, as long as you don't have any tight radius's to cut.

i need to cut just along the wheel well on that part of the body panel

sawzall or grinder. both are great cutting tools. i have cut many parts off of my jeep, and many parts to fab things up for my jeep. i dont own a plasma cutter. hell, i have never even tried one. :wave:
i'll bet it is nice, but unless some very kind, sharing, and generous person steps up to share their equipment with a stranger, :eek: i'd swing by harbor freight for some flap discs, and slitter wheels for your 4.5" grinder ;) :wave:

where is harbor freight my friend told me but i didnt remember where it was

There is one on PCH just past Oak (I think), it is on the south side of PCH, in the same lot as that Pizza Hut.....I think anyway...it has been awhile since I was in that area.

Consider also using a Dremel and cutoff wheels if you have very fine and precise cuts that need to be made (under 5 cm length).

http://www.harborfreight.com/cpi/ctaf/retail_stores.taf#CA

Dukes69 has a plasma cutter, but youll have to come to Temecula :D

Tam :)

I have a plasma cutter (Corona), but would strongly suggest an air body saw.

I have one, but I dont think its the best for the job. A sawsall or some kind of cut off deal would be better. I didnt have any of the when I did mine, so I used tin snips. :eek: :D

I Grew Up In A Body Shop And Still Work In One Today. A Plasma Cutter Is Not The Way To Go For Triming Fenders Or Quarter Panels.LOTS OF SPLATTER AND It Will Give You A Really Rough And Jaged Edge. Not Good For Tires. I Would Run Some Masking Tape Were Your Going To Cut, This Will Protect The Paint Were You Cut,keep It From Chipping And Peeling Back. But For The Cut I Would Use A Cut Off Wheel.

yea i ended up using a cut off wheel to do the job thnx for all the input