View Full Version : Getting rid of spare parts.


locked94yj
03-13-06, 03:53 PM
94 YJ seats. Gray and the drivers seat is worn a little. They still recline and the passenger is in good condition. 50 bucks.

Cragar 397 series steel wheel.The wheel is brand new still in box. 15X8 with 5 on 5.5 bolt pattern asking 40 for it.

Dana 35 3.55 and up carrier. asking 50 for it.

Yj underdash ac unit. worked when it came out. all the connections and hose fittings are still usable all yould need is a compressor under the hood and the hoses to go with it and you would have A/C in your YJ. Asking 100 or obo.

1 set of used rear shocks for a YJ with 4" lift. not sure on the brand but still work great. make me an offer.

2 sets of dana 35 axle shafts used but great to carry as a spare if you still are running a dana 35. 60 bucks per set. and yes they are for a c-clip dana 35.

1 33X12.50 R15 bfg At tire. If you want it come and get it. Not much tread left but good for a spare.

Nocthed cross shaft for a ford 8.8 carrier. brand new. If you plan on running tall gears (numericaly higher) in your 8.8 you need this cross shaft. asking 30 bucks.

One drive shaft from a tj with 1310 ujoints and slip yoke. 40 bucks

One stock rear out put shaft for a np231 tranfer case. 40 bucks.

Davisrats
03-13-06, 07:41 PM
94 YJ seats. Gray and the drivers seat is worn a little. They still recline and the passenger is in good condition. 50 bucks.

Brackets too????

locked94yj
03-14-06, 08:40 AM
sorry no brackets. I can send pictures if you pm me your e-mail address.

locked94yj
03-14-06, 02:11 PM
if no body needs any of this it will go on ebay and then the trash bin.

locked94yj
03-16-06, 09:26 AM
Nobody wants my junk huh? Ok then, I will leave this up till saturday then everything goes on E-bay. If you think I am asking to much for something you need then tell me. I will lower the prices or at least try to bargain with you.

maddmike
03-16-06, 01:48 PM
i've got a stock TJ and the axles/driveshaft look appetizing to me for spares. Will the axles work in the stock D35 ass'y? how about the driveshaft?

thx

locked94yj
03-16-06, 03:29 PM
Yes the axles will work with the stock dana 35 and the drive shaft is from a 6 cyl engine. I am not sure if the lengths are diffrent from a 4cyl or not. I will give you one set of axles and driveline for 75 bucks and you pay shipping or come a pick them up.

zenjeep
03-17-06, 04:47 PM
still have the 8.8 cross? willing to ship to 87110? 20. plus shipping?

locked94yj
03-18-06, 09:16 AM
It cost me 40 and it is still brand new never installed. how about 30 plus shipping.