i need to know all the things i need to about bolting in a AMC 360. motor mounts, cooling system, and anything else i might need to know before i start on this project? thanks

Call Advance Adapters at (805)238-7000, and ask them for their engine and transmission conversion kits manual. There is way too much information for you to need to know to try to relay it all in a forum...

What tranny are you mating that beast to? Don't forget to get a bigger clutch if you are running a Jeep tranny. I'd get an 11" setup... You will probably find out the hard way that a 10 1/2" (esp a stock clutch) is not sufficient.

i am using a t18 tranny with a dana 20 transfer case. do you know anything about the engine,tranny, and transfer case mounts? thanks